High Performance Shielded Cable
The MaxSonar Connection Wire is used to reduce interference caused by electrical noise on the lines. This cable is a great solution to use when running the sensors at a long distance or in an area with a lot of EMI and electrical noise. MaxBotix Inc., has successfully tested our sensors at a distance of 1,000 ft using this wire and it was as stable as if it were next to the power supply.
This accessory is compatible with the following sensor lines that MaxBotix Inc., sells.
MB7954 Datasheet…………………….Shielded Cable Datasheet
All part numbers are a combination of a six-character base followed by a dash and a three-digit product code. Please review the following table for more information on the three-digit product code.
| M | B | 7 | 9 | 5 | 4 | – | 0 | 0 | 0 | ||||||||||
| Base | |||||||||||||||||||
| Housing Style | |||||||||||||||||||
| 0 | Not Applicable | ||||||||||||||||||
| 1 | 3/4″ NPS WR | ||||||||||||||||||
| 2 | 3/4″ NPS WRC | ||||||||||||||||||
| 3 | Ultra Compact | ||||||||||||||||||
| 4 | Ultra Compact Flush Mount | ||||||||||||||||||
| 5 | 1″ NPS | ||||||||||||||||||
| 6 | 1″ BSPP | ||||||||||||||||||
| 7 | 30MM 1.5 | ||||||||||||||||||
| 8 | Extended Horn | ||||||||||||||||||
| Options Selected | |||||||||||||||||||
| 0 | No Options (Bagged) | ||||||||||||||||||
| 1 | F-Option | ||||||||||||||||||
| 2 | P-Option | ||||||||||||||||||
| 3 | F-Option and P-Option | ||||||||||||||||||
| 4 | No Options (Trayed) | ||||||||||||||||||
| 5 | TTL (Bagged) | ||||||||||||||||||
| 6 | TTL (Trayed) | ||||||||||||||||||
| Wire Attach | |||||||||||||||||||
| 0 | No Wire Attach | ||||||||||||||||||
| 1 | Wire Attached | ||||||||||||||||||
The following table displays all of the active and valid part numbers for this product.
| Active Part Numbers |
| MB7954-000 |
Yields a stronger seal for IP68 compliance and operation near harsh chemicals. Select this option on the applicable product page to purchase.
View Product $40.00
Improves snow depth measurements and detection range for people with select sensors. Select this option on the applicable product page to purchase.
View Product $40.00
Connects shielded cable to the pin-out below a sealed cap providing a full IP67 seal. Select this option on the applicable product page to purchase.
View Product $62.92
To ensure easy integration with the Radio Bridge interface, we provide a 5ft cable to connect your sensor to the LoRaWAN Bridge.
View Product